The Furitek SlideTech is a 1/10 sensored ESC for RC drift and stock racing. You can set it up right on the ESC with its trackball and OLED screen, or from the Furitek app. This page collects our SlideTech videos in the order you'll need them, from first setup to fine-tuning. Each section has a short summary so you can jump straight to the part you need.

Jump to: 1. Trackball & OLED setup · 2. Calibrate your transmitter · 3. Pre-Run Safety Check · 4. AC-Flip wiring · 5. Turbo & Boost · 6. Hall Angle (timing) · 7. ABS braking · 8. Rev Limiter

1. Setup with the trackball & OLED screen

SlideTech has a trackball and a built-in OLED screen on the ESC, so you can change settings at the track without a phone or a program card. This video shows how to move through the menus and change values.

2. Calibrate your transmitter

Do this first, after installing the ESC and every time you change radios. Correct calibration gives you the full throttle range and smooth, precise control. Before you start, set your radio's throttle trim, end points and rates to neutral/default.

3. Pre-Run Safety Check

SlideTech checks the sensor connection before the motor runs. If a sensor wire is loose or plugged in wrong, the ESC won't let the motor run until you fix it, which protects the ESC and motor from damage.

4. AC-Flip for clean wiring

AC-Flip lets you route the motor wires the cleanest way for your chassis, however the ESC is mounted. It works on all Furitek SlideTech ESCs.

5. Turbo & Boost

Turbo and Boost add timing to get more wheel speed, for example coming out of a corner. The first video is a quick setup with the SlideTech and Voltmaster motor. The second goes deeper into each setting, including turbo delay, with real driving examples.

6. Hall Angle (motor timing)

Instead of a motor with fixed timing, SlideTech and EagleTech let you raise the motor timing step by step to match your driving style. You can set it in the Furitek app or on the OLED screen.

7. ABS braking

What ABS braking is, why it helps in drifting and racing, how to turn it on, and how braking compares between SlideTech and SlideTech PRO.

8. Rev Limiter

The Rev Limiter cuts the throttle at a set RPM, so your drift car sounds like a real car bouncing off the limiter. It's adjustable from 5,000 to 100,000 RPM.

Products in these videos

• SlideTech PRO Trackball 1/10 Sensored ESC (also in Black, Red and Purple)
• SlideTech 1/10 Sensored ESC
• SlideVolt Combo (SlideTech ESC + Voltmaster motor)
• All 1/10 drift and race electronics: Furitek 1/10 Drift & Race

Having a problem? Check the Troubleshooting Guide or email sales@furitek.com.